How To Nail Vinyl Siding
How to Smash Vinyl Siding Correctly
Updated: May 06, 2019
Rule #1: Let it move
Vinyl siding will pop and crepitation with every alter of sunlight and temperature if nailed incorrectly. Hither's how to fix the problem if you lot have it, and how to nail (or renail) siding and so that it moves freely and silently for the life of your house.
You might also similar: TBD
Diagnosing and fixing noisy siding
Photo 1: Exam each piece
Each piece of siding should movement back and forth at least 1/4-in. if it'due south been nailed correctly. Test all the pieces on the noisy wall, and mark pieces that don't move.
Photo 2: Unzip the siding
Unlock the course of siding to a higher place the tightly nailed piece, sliding the unlocking tool along underneath the lap.
Photo three: Expose the nails
Elevator the siding up and await for nails that take been hammered in too tightly.
Photograph 4: Cut the nails
Loosen the tight blast, or cut it with a hacksaw. Renail the siding, keeping the new blast in the center of the nailing slot and leaving it about ane/16-in. upwards off the siding.
If your siding sounds like rodents running inside the walls whenever the sun shines on it, y'all may have one or more pieces that were nailed too tightly. Vinyl siding tends to expand and contract considerably with temperature changes. For this reason, manufacturers blueprint it to hang loosely on the nails rather than to be tightly nailed like wood siding.
The problem should be like shooting fish in a barrel to diagnose. But get outside, grab the lower edges of a siding course and effort to slide it back and forth (Photo 1). Manufacturers require near 1/4-in. play at both ends, so if it's nailed properly (loosely), you should be able to slide information technology one/4 to i/two in. If all the siding is tight, it was installed wrong and should be redone. If but a few pieces are tight and you can't find the contractor who installed it, buy an unlocking ("zip") tool and unfasten the section above, exposing the nails (Photos ii and 3). Find the tight nails and cutting them (Photo four). Renail right adjacent to the old smash, leaving at least a i/16-in. gap between the nailhead and the vinyl to allow easy motility.
Required Tools for this Project
Take the necessary tools for this DIY projection lined upwardly before y'all starting time—you'll save time and frustration.
Required Materials for this Projection
Avert last-infinitesimal shopping trips by having all your materials set ahead of fourth dimension. Here's a list.
Originally Published: May 06, 2019
Source: https://www.familyhandyman.com/project/how-to-nail-vinyl-siding-correctly/
Posted by: isaacouster.blogspot.com
0 Response to "How To Nail Vinyl Siding"
Post a Comment